Form Center

2. 1. Original lot/property surveys prepared within the last 12 months of the permit application, signed and sealed by a land surveyor licensed/registered in the State of Florida;
4. 1. Plot plans of the surveyed lot/site depicting the structure(s) drawn to scale, make sure any easements are on the plot plan
6. 1. Location and dimension of driveway(s) and walkway(s) – Code requires 16-ft, the intent is for two cars to park next to each other
8. 1. Material of driveway(s) and walkway(s) – concrete, asphalt, brick
10. 1. Culvert under driveway dimensions, elevations – minimum standard 18” RCP
12. 1. Location of water and sewer lines in the ROW that will be tapped. If existing connections exist form prior establishment, the location of the meter and clean-out
14. 1. Sanitary sewer clean-out installed at the property line – if a clean-out is in a driveway it shall be traffic rated
16. 1. Location of lateral connection to the structure(s) – prefer to not have them under driveway(s)
18. 1. Location of water service connection to the structure(s) – prefer to not have them under driveway(s)
20. 1. Location of the nearest fire hydrant to the lot/site (this can be a directional note)
22. 1. Proposed lot grading plan – all stormwater directed towards street or approved drainage easement/area, not onto neighboring lots
24. SFHA

    1. Homes in Coastal A Zones only Columns, Pilings or Piers may be used with Lowest Horizontal Structural member at BFE + 1 foot or all other SFHA lowest Finished Floor Elevations in NAVD
Leave This Blank:


25. Print Only

* indicates a required field